Toshiba Tosvert VF-AS1 - Manual (Page 13)

E6581301
iii
6.23 Increasing the motor output torque further in low speed range F-39
6.24 Torque control F-40
6.24.1 Torque command F-40
6.24.2 Speed limits in torque control mode F-40
6.24.3 Torque bias and load sharing gain F-40
6.25 Torque limit F-42
6.25.1 Torque limit switching F-42
6.25.2 Torque limit mode selection at acceleration/deceleration F-44
6.26 Stall prevention function F-46
6.26.1 Power running stall continuous trip detection time F-46
6.26.2 Regenerative braking stall prevention mode selection F-46
6.27 Current and speed control gain F-46
6.28 Fine adjustment of frequency setting signal F-47
6.29 Operating a synchronous motor F-47
6.30 Acceleration/deceleration 2 F-48
6.30.1 Setting acceleration/deceleration patterns and switching acceleration/deceleration
patterns 1, 2, 3 and 4
F-48
6.31 Pattern operation F-51
6.32 Preset speed mode F-53
6.33 Protection functions F-54
6.33.1 Setting of stall prevention level F-54
6.33.2 Inverter trip record retention F-54
6.33.3 Emergency stop F-55
6.33.4 Output phase failure detection F-56
6.33.5 OL reduction starting frequency F-56
6.33.6 Motor 150%-overload time limit F-56
6.33.7 Input phase failure detections F-56
6.33.8 Control mode for low current F-57
6.33.9 Detection of output short circuit F-57
6.33.10 Overtorque trip F-58
6.33.11 Cooling fan control selection F-59
6.33.12 Cumulative operation time alarm setting F-59
6.33.13 Abnormal speed detection F-60
6.33.14 Overvoltage limit operation F-60
6.33.15 Undervoltage trip F-60
6.33.16 Regenerative power ride-through control level F-61
6.33.17 Braking answer waiting time F-61
6.33.18 VI/II analog input wire breakage detection level F-61
6.33.19 Guide to time of replacement F-62
6.33.20 Rush current suppression relay activation time F-62
6.33.21 Motor thermal protection F-62
6.33.22 Braking resistance overload curve F-62
6.34 Override F-63
6.35 Adjustment parameters F-65
6.35.1 Pulse train output for meters F-65
6.35.2 Setting of optional meter outputs F-66
6.35.3 Calibration of analog outputs F-66
6.36 Operation panel parameter F-66
6.36.1 Prohibition of key operations and parameter settings F-67
6.36.2 Displaying the rotational speed of the motor or the line speed F-68
6.36.3 Changing the steps in which the value displayed changes F-69
6.36.4 Changing the standard monitor display F-70
6.36.5 Canceling the operation command F-70
6.36.6 Selection of operation panel stop pattern F-70
6.36.7 Setting of a torque command in panel operation mode F-70
6.36.8 Torque-related parameters for panel operation F-71
6.37 Tracing functions F-71
6.38 Communication function F-75