Toshiba Tosvert VF-AS1 - Manual (Page 189)

E6581301
F-77
6
Title Function Adjustment range Default setting
H Frequency point selection
:Disabled
:2-wire RS485
:4-wire RS485
:Communication add option
H Point 1 setting ~%
H Point 1 frequency ~HJHz
H Point 2 setting ~%
H Point 2 frequency ~HJHz
Inverter with a model
number ending with
-WN:
-WP:
H Block write data 1
:Deselect
:Command information 1
:Command information 2
:Frequency command
:Terminal board output data
:Communication analog output
H Block write data 2 Ditto
H Block read data 1
:Deselect
:Status information
:Output frequency
:Output current
:Output voltage
:Alarm information
:PID feedback value
:Input terminal board monitor
:Output terminal board monitor
:VI/II terminal board monitor
:RR/S4 terminal board monitor
:RX terminal board monitor
:Input voltage (DC detection)
:Speed feedback frequency
:Torque
:MY monitor 1
:MY monitor 2
:MY monitor 3
:MY monitor 4
:Free notes
H Block read data 2 Ditto
H Block read data 3 Ditto
H Block read data 4 Ditto
H Block read data 5 Ditto
H Free notes ~HHHH
* : No action .... No action is taken even if a timeout occurs.
Alarm ......... An alarm goes off if a timeout occurs.
The message “V” blinks at the left end of the operation panel.
Trip ............. The inverter trips when a communication time-over occurs.
The message “GTT” blinks on the operation panel.
Note:Changes to the parameters H, H and H do not take effect until the power is turned off and
then on again.