Toshiba Tosvert VF-AS1 - Manual (Page 193)

E6581301
F-81
6
Title Function Adjustment range Default setting
H Block read data 1
:Deselect
:Status information
:Output frequency
:Output current
:Output voltage
:Alarm information
:PID feedback value
:Input terminal board monitor
:Output terminal board monitor
:VI/II terminal board monitor
:RR/S4 terminal board monitor
:RX terminal board monitor
:Input voltage (DC detection)
:Speed feedback frequency
:Torque
:MY monitor 1
:MY monitor 2
:MY monitor 3
:MY monitor 4
:Free notes
H Block read data 2 Ditto
H Block read data 3 Ditto
H Block read data 4 Ditto
H Block read data 5 Ditto
H Free notes ~HHHH
* : No action .... No action is taken even if a timeout occurs.
Alarm ......... An alarm goes off if a timeout occurs.
The message “V” blinks at the left end of the operation panel.
Trip ............. The inverter trips when a communication time-over occurs.
The message “GTT” blinks on the operation panel.
Note:Changes to the parameters H, Hand H do not take effect until the power is turned off and
then on again.
6.38.2 Open network option
H ~ H : Communication option settings 1 to 7
H ~ H : Communication option settings 8 to 13
H : Disconnection detection extended time
H : Inverter operation at disconnection
H : Preset speed operation selection
H , H : Selection of monitoring
⇒ For details, refer to Instruction Manual (E6581280, E6581342) specified in Section 6.41.
6.39 My function
H : Input function target 11~ H : My function selection
⇒ For details, refer to Instruction Manual (E6581335) specified in Section 6.41.