Toshiba Tosvert VF-AS1 - Manual (Page 117)

E6581301
F-5
6
• Function
These parameters are used to switch signals to be sent to the analog input terminals VI/II and AI2 (optional).
ST-CC
3-CC
(Jog run)
Output frequency [Hz]
Forward run
Forward run
Set frequency
Panel key RUN STOP RUN STOP RUN STOP
6.2.3 Binary/BCD signal selection (Expansion TB option unit)
H : 16-bit binary/BCD input selection (Expansion TB option unit)
To be released soon.
6.2.4 Analog input signal switching
H : Analog input VI/VII voltage/current switching
H : Analog input AI2 (optional circuit board) voltage/current switching
[Parameter setting]
Title Function Adjustment range Example of setting
H Analog VI/VII voltage/current switching
: Voltage input
: Current input
H
Analog input AI2 (optional circuit board)
voltage/current switching : Voltage input
: Current input
When using the analog input terminal VI/II
as a voltage input terminal (VI)
H
=
When using the analog input terminal VI/II
as a voltage input terminal (II)
H
=
CCA VI/II
0~10V input
CCA VI/II
0~20mA(4~20mA) input
CCA: Analog common
⇒ For an explanation of input gain and bias adjustments, refer to Section 6.28.