Toshiba Tosvert VF-AS1 - Manual (Page 17)

E6581301
A-1
1
1. Read first
1.1 Check product purchase
Before using the product you have purchased, check to make sure that it is exactly what you ordered.
Warning
Mandatory
Use an inverter that conforms to the specifications of the power supply and three-phase induction
motor being used. If the inverter being used does not conform to those specifications, not only will the
three-phase induction motor not rotate correctly, but it may cause serious accidents through
overheating and fire.
Type indication
label
Series name
Power supply
Motor capacity
Inverter Type
Applicable motor
Invert rated output capacity
Power supply
Related input current
Related output current
Serial No.
Type indication Inverter main unit
Carton box
Name plate
Warning label
VF-AS1
Type indication
Name plate
Warning label
Instruction manual
This manual
DANGER
15
Risk of injury, electric shock or fire. Read the Instruction Manual.
Do not open the cover while power is applied or
for 15 minutes after power has been removed.
Ensure proper earth connection.
1. 2 Contents of the product
Explanation of the type and form written on the label.
Type Form
Ｖ Ｆ Ａ Ｓ １ － ２ ０ ３ ７ Ｐ Ｌ Ｙ － Ｗ Ｎ － Ａ ２ ２
Model name
TOSVERT
VF-AS1 series
VFZ1: For explosion-
proof motors
Operation panel
P:Provided
Additional functions II
F:External heat sink
Y:Others
(non-standard)
Applicable motor capacity
004:0.4kW
007:0.75kW
015:1.5kW
022:2.2kW
037:3.7/4.0kW
055:5.5kW
075:7.5kW
110:11kW
150:15kW
185:18.5kW
220:22kW
300:30kW
370:37kW 450:45kW
550:55kW
750:75kW
900:90kW
110K:110kW
132K:132kW
160K:160kW
200K:200kW
220K:220kW
280K:280kW
355K:355kW
400K:400kW
500K:500kW
Voltage class
2:200V~240V
4:380V~480V
Special
specification code
A††:
Special:
specification code
(††is a number)
Additional functions I
L: Built-in EMC filter
+
basic filter
M: Built-in basic filter
C: Built-in EMC filter
Special specification code
Default interface
logic*
WN: Negative
WP: Positive
* This code represents the factory default logic setting. You can switch from one input/output logic to the other using
slide switch SW1. ⇒ For more details, refer to Section 2.3.2.
Warning : Always shut power off first then check the ratings label of inverter held in a cabinet.