Grass Valley Trinix NXT v.3.3.1 - Manual (Page 378)

378 Trinix NXT — Installation and Service Manual
Section 10 — Encore Control
2. Rebooting Encore with no matrix present:
• The Trinix routing switcher, with single NR card already installed,
is powered up after Encore. Encore will detect the addition of the
matrix controller but there was no correspondence prior to deletion
of the same matrix controller.
• This condition tells Encore that the RCE MAP may not be correct
and the MAP should be read back from the matrix and used to
refresh the RCE status.
This is also true when Encore rebooted and starts up with a Trinix
routing switcher already running with single NR card installed.