Grass Valley Trinix NXT v.3.3.1 - Manual (Page 269)

Trinix NXT — Installation and Service Manual 269
Software Installation
Updating Systems with Two Broadlinx Boards
This section describes the steps for updating existing Broadlinx boards. The
Installation process uses the Broadlinx Firmware Management Web page.
These steps are described below.
Follow these steps to update all the boards within the frame (except an
active NR-33000 board):
1. Remove the Broadlinx boards from the chassis and remove the existing
compact Flash card by pressing the Eject button (
Figure 178 on
page 270 ).
Note For the Asymmetric frames, the NR-33000 (Broadlinx) board is turned side-
ways, so the Eject button is at the bottom.
For Encore controlled systems, the memory must be cleared by discon-
necting the battery terminal, leave it un-connected for couple of min-
utes, and then reconnect the battery (
Figure 177 ).
Figure 177. Battery location on the NR-33000.
2. Insert the Compact Flash card into the slot on the Broadlinx board and
then insert the Broadlinx boards into the frame. Broadlinx will then
inventory the boards that are in the frame.
071828316-BATTERY CONNECTION
Battery terminal location