Grass Valley Trinix NXT v.3.3.1 User Manual
Page 332
332
Trinix NXT — Installation and Service Manual
Section 7 — Broadlinx Console Commands
Table 68. M
Command
Arguments Detailed
Description
moduleIdShow
(int verbose)
Prints information about all known devices.
Table 69. N
Command
Arguments Detailed
Description
netConfigShow
()
No Help Text (netConfig.cc)
nrUpTime
(void)
Displays the total time the system has been alive.
Table 70. O
Command
Arguments Detailed
Description
outputMonitorShow
(int verbose)
Show output monitor status.
verbose can be 1 or 2 for more or still more verbosity.
outputStatusShow
(int startingOutput, int end-
ingOutput)
Show output status.
Table 71. P
Command
Arguments Detailed
Description
pollMetricsReset
(int val)
Reset debug polling metrics.
pollShow
(void)
Display debug polling metrics
pollStep
(int n, int to, int frame, int
slot)
Debug polling metrics pollStep(N, to)
Step N polls or step to a polling state: 1=active, 2=inac-
tive, 3=frame, 4=dev
dev to step to is frame and slot
If N is zero toggle polling
postHandlerShow
()
No Help Text (prj_post.c)
printLog
()
Prints the log messages from the log buffer.
protectedPathSet
(int startingOutput, ULONG
lockStat, ULONG overStat)
Diagnostic use only.
Calls the device update function like the device master
does to update the output status. The starting output is
a multiple of 32 and would be the first output on an
output card. The lockStat and overStat are bits that
indicate whether the output is present and enabled
starting with the least significant bit. If the output is
overridden then the output is disabled (off).
protectedPathsFileInit
(void)
Diagnostic use only.
Calls PathInit() directly.
PathInit restores the protected path data from the
paths.dat file. See the
protectedPathsReset function.
protectedPathShow
(int startingOutput, int end-
ingOutput)
Show protected path output status.