Grass Valley Trinix NXT v.3.3.1 - Manual (Page 220)

220 Trinix NXT — Installation and Service Manual
Section 3 — Hardware Installation
3. On TRX-NXT-512x512 units only, a Crosspoint bus cable must be
installed between the power supply frame and the main frame.
If there is more than one TRX-NXT-512x512 in the system, the Cros-
spoint bus must be daisy-chained between units.
The Crosspoint bus must be terminated at the farthest point from the
controlling Broadlinx board.
This connection is shown on Figure 68 .
The Crosspoint bus cable is described on Figure 124 .
4. Install LAN components as described beginning on page 221.
5. Refer to the SMS 7000 or Encore documentation for control system
configuration details.