Complex network – Grass Valley Trinix NXT v.3.3.1 User Manual
Page 288
288
Trinix NXT — Installation and Service Manual
Section 6 — Broadlinx Software
Note
If you connect to the Internet via a Proxy, you must turn off the Explorer Proxy
settings. To check the Proxy setting, open Microsoft Internet Explorer’s LAN
Settings (Menu bar> Tool > Internet Options> Connections> LAN Settings).
2.
Enter the factory default URL in the address field (This URL is the IP
address for the Broadlinx board):
http://192.168.253.200
The Broadlinx web page will then appear.
Figure 197. Broadlinx Web Page
3.
Proceed to the Broadlinx Installation
Note
There is a known issue where the Broadlinx Web page is not accessible if the
Broadlinx board is started without an Ethernet cable or if the Ethernet cable
is removed and then inserted after HTTP Daemon is started. However, the
Trinix Matrix will be listed in the NetConfig application. To correct this issue,
insert the Ethernet cable and then reboot the Broadlinx board.
Complex Network
If the network includes additional PCs, connections to additional net-
works, and so forth or if there is more than one Broadlinx board, then the
factory default network settings of the boards will need to be adjusted to
avoid conflicts.
See the
Configuring the PC’s Network Settings
section, for the initial network
configuration steps.
When the Broadlinx web page appears:
1.
Click the
Configure
button, at the bottom of the page, to navigate to the
). You should see the current Network
Interface parameters. Your parameters will differ from those in the
example shown in