Grass Valley Trinix NXT v.3.3.1 - Manual (Page 197)

Trinix NXT — Installation and Service Manual 197
Output Reclocker Bypass Settings
Output Reclocker Bypass Settings
The following discussion applies to units equipped with the HO-33110 HD
or the HO-33120 SD/HD/3G Output Boards.
Front edge dual in-line package (DIP) switches S5-8 and S1 through S4 on
these output boards are used to control reclocking.
Figure 111.
Switch settings are shown in Table 39 .
Table 39. Reclock settings for HD output boards.
“Reclock if possible” means the signal will be checked to see if it is properly
formed and running at a standard data rate supported by this board model.
If so, the signal will be reclocked.
“Bypass” means the signal will not be reclocked.
S5-8
“AUTO RCLK”
Switch on S1
through S4
Reclock all outputs if possible. Bypass unlocked outputs.
(Default setting)
Closed All closed
Bypass all outputs Open All open
Reclock selected outputs if possible, otherwise turn OFF.
Bypass all other outputs
Open
Closed for selected out-
puts. All others open
SYNC SEL A
SYNC SEL B
AUTO RCLK
Open Closed
BYPASS 0
BYPASS 1
BYPASS 2
BYPASS 3
BYPASS 4
BYPASS 5
BYPASS 6
BYPASS 7
BYPASS 8
BYPASS 9
BYPASS 10
BYPASS 11
BYPASS 12
BYPASS 13
BYPASS 14
BYPASS 15
BYPASS 16
BYPASS 17
BYPASS 18
BYPASS 19
BYPASS 20
BYPASS 21
BYPASS 22
BYPASS 23
BYPASS 24
BYPASS 25
BYPASS 26
BYPASS 27
BYPASS 28
BYPASS 29
BYPASS 30
BYPASS 31
S5
S1
S2
S3
S4
These functions apply
to HO-33110/33120
output boards only