Grass Valley Trinix NXT v.3.3.1 - Manual (Page 324)

324 Trinix NXT — Installation and Service Manual
Section 6 — Broadlinx Software
Updating the FPGA Firmware for a Group
1. Type
updateFpgaGroup 26
At the Command prompt.
The following will then occur:
• The lights on the selected boards will then go red.
• The update process will then look for and then report the selected
board types in the different slots.
For example:
value = 0 = 0x0
Trinix1 > 20000528.000111: FPGA update
requested for frame 0 slot 32 (class 2, type
26). (deviceMaster.cc:977)
The search progress is displayed by a percent, when it is finished 100%
done will be displayed. See the text below:
value = 0 = 0x0
Trinix1 > 20000528.000111: FPGA update
requested for frame 0 slot 32 (class 2, type
26). (deviceMaster.cc:977)
20000528.000111: FPGA update requested for
frame 0 slot 33 (class 2, type 26).
(deviceMaster.cc:977)
20000528.000111: FPGA update requested for
frame 0 slot 34 (class 2, type 26).
(deviceMaster.cc:977)
20000528.000111: FPGA update requested for
frame 0 slot 35 (class 2, type 26).
(deviceMaster.cc:977)
20000528.000111: Updating: 4 FPGA(s) for group
8582 (class 2, type 26). (deviceMaster.cc:1015)
100% done
The update process will then begin. When a card is updated a report
will tell you if the update was a success or not and that the card must
be restarted. See the text below.
20000528.001749: FPGA update succeeded for
frame 0 slot 32, new version is 2. Card must be
re-powered to use new version. (deviceMa)