Grass Valley Trinix NXT v.3.3.1 - Manual (Page 309)

Trinix NXT — Installation and Service Manual 309
Configuration
Licensing SNMP on Both Broadlinx Boards
SNMP is licensed for a frame type using the hardware Ethernet address of
the Broadlinx or NR33300 processor. (MAC Address)To license a newly
added standby board either in the primary or secondary slot type setSn-
mpCommunicationsEnable
and wait for the SNMP license set message
then reboot the board.
An alternative to licensing both boards is to enable inter-board communi-
cations to save the license key from the active board that has been licensed
to the standby board.
The setSnmpCommunicationsEnable command will allow the SNMP
key to be saved from the active board to the inactive board. Inter-board
communications of the license key is verified with the
redundantConfigShow
command.
Follow these steps to save the license key from the primary board:
1. Start a console or telnet connection to the standby Broadlinx board
2. Enter setSnmpCommunicationsEnable at the command prompt.
The SNMP license should now be saved to the secondary board.
3. Enter the redundantConfigShow command at the command prompt
to verify that the communications is active and that the SNMP license
key had been transferred.
4. Once the key is transferred the board should be rebooted.