Grass Valley PROFILE FAMILY v.2.5 - Manual (Page 43)

Setting Master Timecode
Profile Family 43
4. For each video output that should have VITC, select it from the list:
• For analog composite on preexisting PDR100 and PDR200 units:
- Verify VITC Generator Enable is checked. If not, click to toggle it.
- Click on Vert. Interval to open the Vertical Interval Line Programming
dialog box.
- Select the desired VITC lines by checking in the VITC Enable column for
the line. There is not a limit on the number of VITC lines.
- Click Close to close the Vertical Interval Line Programming dialog box.
• ²For serial digital component:
- From the Serial Digital Component Video Output dialog box, set the lines
where you want VITC in VITC Generator Line1 and VITC Generator
Line2.
- Verify VITC Generator Enable is checked. If not, click to toggle it.