Grass Valley PROFILE FAMILY v.2.5 - Manual (Page 226)

Chapter 6 Using Profile Utilities
226
- For timecode generators:
timecode format, timecode mode, time to seed, user bits to seed
If you don’t specify parameters, the default values are used. You can
override the defaults in the .cfg file, or by using the API calls. Acceptable
values for these parameters are shown in Table 14
Each resource allocation line is assigned an index number in sequential order
independent of comment lines or crosspoint lines. Thus, the first resource line
found in an NCS file is assigned index number 1, the second is assigned index
number 2, etc. These index numbers may be used by the crosspoint lines, which
are described in the following section.
Table 14. Timecode Parameters
Parameter Acceptable Values Default
timecode
format 0 = Drop-frame
1 = Non-drop frame 1
timecode
mode 0 = TcModeFreeze
1 = TcModeFreeRun
2 = TcModeFieldLocked
3 = TcModeRegenHold
4 = TcModeRegenFlywheel 2
time to seed frame, second, minute, hour
user bits to
seed 32 bits, in reverse byte order
(last, third, second, first)