Grass Valley PROFILE FAMILY v.2.5 - Manual (Page 30)

Chapter 1 Introducing the Profile Family
30 Profile Family
Starting Your Profile System
Once the unit is properly installed, you are ready to log in. For instructions on
how to install and power-on a PDR 100, PDR200, or PDR300 see the
installation manual that came with the unit.
To log in automatically:
Power up the Profile unit, and the start up routine begins. During normal start
up, you are logged in automatically and the VdrPanel application starts. You
can hold down the
Shift key during start up to interrupt the automatic log in
process.
NOTE: If you stop the automatic log in, or if it fails, the Windows NT
log in dialog box appears. When logging in, remember that this
dialog box is case-sensitive.
To manually log in:
1. At the Windows NT 4.0 log in window, enter the username: profile
(However, you must log in as administrator when installing software,
performing Windows NT administration, starting a service, or setting an
Ethernet IP address.)
2. Use the Tab key to advance to the password field.
3. The password appears as asterisks (*) for password security. For the
password, enter: profile
4. Use the Tab key to advance to the From field.
5. If your domain name or local computer name is not displayed in the box,
click in the box to access a list of choices. Select your domain or local
computer name from the list.
6. Click OK or press Enter.
NOTE: If a log in error message appears, and all the information is
correct, try deleting the password and clicking
OK .