Grass Valley PROFILE FAMILY v.2.5 - Manual (Page 245)

Fibre Channel IP Address Set Up
Profile Family 245
3. For PROFILE1 in this example, type the following:
NOTE: Do not reboot when prompted.
192.168.100.1 followed by Enter
FC IP address set to 100.100.100.1
Reboot computer for settings to take effect!
fcconfig -g 255.255.255.0 followed by Enter
Gateway set to 255.255.255.0
Reboot computer for settings to take effect!
NOTE: Based on the address you use for a subnetmask, there is an
implicit subnetmask, but you can override this with a larger mask.
For example,
255.0.0.0 can be overridden by 255.255.0.0 or
255.255.255.0 .
fcconfig -a 1 followed by Enter
Address set to 1
Reboot computer for settings to take effect!
NOTE: The hardware address can be any number between 1 and 120.
In these examples, use
1 for PROFILE1 and 2 for PROFILE2 . No two
hardware addresses should be the same on the network.
fcconfig -t off followed by Enter
TCP/IP checksums are now disabled.
Reboot computer for settings to take effect!
fcconfig -hta off followed by Enter
Auto host table administration set to off.
Reboot computer for settings to take effect!
4. Now type fcconfig again followed by Enter:
Fibre Channel Network Configuration:
FC IP Address .................... : 192.168.100.1
Hardware Address ................. : 1
TCP checksums .................... : Disabled
Auto host table administration ... : Disabled
F/C Switch ....................... : Disabled