Grass Valley PROFILE FAMILY v.2.5 - Manual (Page 351)

Automatically Starting the TimeDelay Process
Profile Family 351
Automatically Starting the TimeDelay Process
When you select an external VITC or LTC signal as TimeDelay’s timecode
source, you can start the TimeDelay process automatically when a specific
timecode value is reached. This feature allows you to synchronize multiple
Profiles that are using the same external timecode source.
To automatically begin recording at a set timecode:
1. Choose Config | Timecode Source…
2. Select an external timecode source.
3. In the Record Panel, click the Auto Start button, or choose
Config | AutoStart . The Auto Start… dialog box appears (see Figure 174).
4. Click the Auto Start check-box.
5. Enter the desired start time in the Start Time field. This time should be at
least 10 seconds ahead of the current time.
6. Click the Close button.
When you activate auto start, a countdown is shown on the record panel. When
the countdown gets to 00:00:00:00, recording begins.
Figure 174. The Auto Start dialog box