Setting marks, Removing marks, Trimming clips – Grass Valley PROFILE FAMILY v.2.5 User Manual
Page 201: Setting marks removing marks trimming clips

Setting Marks
Profile Family
201
Setting Marks
To set a new in mark and out mark in a clip:
1. Click a panel to select it.
2. Create a clip, load a clip, or load a clip list and then select a clip from the list.
The
Clip Position Bar
is all the way to the left and the
Timecode
is
00:00:00:00.
3. Use the transport controls, drag the
Clip Position Bar
, or click on the
Timecode display to enter a timecode to locate the frame where you want to
set the in mark.
4. Click
Set In Mark
. The
Timecode
display remains the same, but the
Clip
Position Bar
jumps to the far left, indicating the mark-in point on the clip.
5. Use the transport controls, drag the
Clip Position Bar
, or click on the
Timecode display to enter a timecode to locate the frame where you want to
set the out mark.
6. Click
Set Out Mark
. The
Timecode
display remains the same, but the
Clip
Position Bar
jumps to the far right, indicating the mark-out point of the clip.
7. Drag the
Clip Position Bar
to the beginning of the clip.
8. Click
Play
. The clip starts at the in mark and stops at the out mark.
Removing Marks
To remove in and out marks from a clip:
1. Select a clip containing marks in the
Clip Name
box.
2. Click the
Remove In Mark
button to remove a mark-in point and reset the
clip beginning to the actual start of the clip.
3. Click the
Remove Out Mark
button to remove the mark-out point and reset
the clip ending to the actual end of the clip.
Trimming Clips
You can trim a clip from the beginning of the clip to the in mark or from the out
mark to the end of the clip. This action affects all copies of the clip on all panels.
The trimmed material is not retrievable. A warning message and verification
prompt are displayed before the function completes.