Measurement Computing TempScan/1100 - Manual (Page 286)

C-16 Program Examples in Quick Basic 879696 TempScan / MultiScan, Appendix C
The following program is ALARM2.BAS in the \EXAMPLES\ subdirectory. It will set up the alarm system
of the TempScan/1100.
• Lines 1-3: Although not necessary, it is good practice to reset the TempScan/1100 at the start of your
application by sending the Reset Power-On ( *R ) command. Wait a few seconds.
• Lines 4-8: To be certain that the reset was successful and the device is ready, Serial Poll the device
until the proper status is returned.
• Line 9: The Configure Channels (
C ) command will be used once to configure a range of channels
from 1 to 32 as Type T thermocouples, where levels above 18 or below 1 will cause a system alarm.
• Line 10: In addition to causing an internal system alarm state, the alarm conditions can also be
attached to any one of the 32 digital output lines. The Assign Digital Alarm Output ( A ) command will
be used to assign input Channels 1 and 2 to digital alarm Output 1 in an ORed fashion.
• Lines 11-12: Program for one Pre-Trigger scan via the Set Counts (
Y ) command. Then program the
Trigger (trigger start event) and Stop (trigger stop event) via the Set Trigger Configuration ( T )
command to arm the acquisition.
• Lines 13-34: The Set Digital Outputs (
O ) command O? will be used to query the status of the digital
output lines. The alarm state can be detected since digital alarm Output 1 was mapped into input
Channels 1 and 2. This example shows alarm detection handling when two or more channels have to
be muxed into one single digital output bit.
The User Status ( U ) command U11 will be used to show each individual channel alarm status.