Measurement Computing TempScan/1100 - Manual (Page 204)

A-8 API Command Reference 889897 TempScan / MultiScan User’s Manual
Command Syntax Description
J Calibrate Cold Junction
Offset
Jchan,
type,
temp
Calibrate the cold-junction offsets for cold-junction
compensation of the thermocouple signals where chan is
the channel number such that 1 < chan < max , where max
= 992 for the TempScan/1100 and max = 744 for the
MultiScan/1200.
type is the thermocouple channel type.
temp is the reference temperature currently being applied to
the selected channel, with the form nnn.n in degrees º C.
Kkey Enter Calibration Mode if the keyword (or password) is correct,
where key is the keyword in the form of a 5-digit number
nnnnn . Therefore the password can be no longer than 5
characters.
K Enter Calibration Mode
K? Query Kkey as defined above.
Lchan,
level,
hyst
Sets the level against which the testing of channel readings
should be performed where chan is the channel number
such that 1 < chan < max , where max = 992 for the
TempScan/1100 and max = 744 for the MultiScan/1200.
level is the level against which the readings are tested to
determine if the level has been exceeded.
hyst is the hysteresis level.
L Set Trigger Level
L? Query the current level settings
L# Set Scan Rate
(TempScan/1100
only)
L#rate Specify whether to select the optional slow scan rate or to
select the default fast scan. Valid options for rate are: 0 -
Select fast scan rate (default), and 1 - Select slow scan rate.
Mmask Use the IEEE 488 Service Request ( SRQ ) mechanism to
inform the IEEE 488 bus controller of certain conditions,
where
mask is in the form of the number nnn such that
000 < nnn < 255 is summed from the following conditions:
128 - SRQ on Buffer Overrun.
032 - SRQ on Event Detected.
016 - SRQ on Message Available (MAV).
008 - SRQ on Scan Available.
004 - SRQ on Ready.
002 - SRQ on Trigger Event.
001 - SRQ on Alarm.
000 – Clear SRQ Mask.
M Set SRQ Mask
M? Query the SRQ mask.
M# Set Measuring Mode
(MultiScan/1200
only)
M#mode Specify measuring mode. Valid options for mode are: 0 -
Line-cycle integration / high-speed multi-channel mode, and
1 - Single-channel high-speed burst mode.
Nmask Directly sets the Event Status Enable Register ( ESE ) where
mask is in the form of the number nnn such that 000 <
nnn < 255 is summed from the following conditions:
128 – ESB on Power On
064 – ESB on Buffer 75% Full
032 – ESB on Command Error
016 – ESB on Execution Error
008 – ESB on Device Dependent Error
004 – ESB on Query Error
002 – ESB on Stop Event
001 – ESB on Acquisition complete
000 – ESB on Clear Event Mask
N Set Event Mask
N? Query the Event mask.