Measurement Computing TempScan/1100 - Manual (Page 208)

A-12 API Command Reference 889897 TempScan / MultiScan User’s Manual
@
- Trigger On Command
TYPE Acquisition
EXECUTION Deferred
SYNTAX @ Trigger upon receipt of an @
DESCRIPTION
The Trigger On (
@ ) command will start or stop the acquisition accordingly when the start or stop arguments
of the Set Trigger Configuration ( T ) command is set to 1 (trigger on). The T command is used as a trigger source
and follows the same rules as other trigger sources as defined by the T command.
The @ command is valid only when an acquisition is configured such that either the Trigger (trigger start event)
and/or Stop (trigger stop event) is defined as the Trigger On ( @ ) command. Otherwise, if this command is issued
such that either the Trigger and/or Stop are not defined as the Trigger On ( @ ) command, an error condition will
occur.
EXAMPLE
PRINT#1, “OUTPUT07;T1,1,0,0X” ‘ Configure an acquisition with both Trigger and Stop
being assigned the Trigger On ( @ ) command
PRINT#1, “OUTPUT07; @X” ‘ Start the acquisition
SLEEP 10 ‘ Wait 10 seconds to collect data
PRINT#1, “OUTPUT07; @X” ‘ Stop the acquisition