Basler Electric DGC-2020HD - Manual (Page 67)

9469300990 Rev B 57
Oil Pressure
BESTCOMSPlus ® Navigation Path: Settings Explorer, Programmable Senders, Oil Pressure
Front Panel Navigation Path: Not available through the front panel
Figure 21 illustrates the Oil Pressure screen found in BESTCOMSPlus ® . Settings are listed in Table 27.
To program the oil pressure sender, perform the following procedure:
1. Click on Load Oil Settings File and select the appropriate sender file from the list.
2. If no sender file matches the sender being used, the individual points that correlate resistance to oil
pressure level may be modified. This can be achieved by setting numeric values in the table or
dragging the points of the graph to the desired characteristic. Information on sender characteristics
should be obtained from the sender manufacturer.
3. Select Positive or Negative sender slope as required for the desired sender graph.
4. Click Save Oil Data to save the data in the current settings file.
5. If you want to save newly entered sender data as a sender library file, click Create Oil Settings File
and enter a file name and location to save the file.
6. Click the Send Settings button in BESTCOMSPlus
® to send the sender settings to the DGC-2020HD.
Figure 21. Settings Explorer, Programmable Senders, Oil Pressure Screen
Table 27. Settings for Oil Pressure Screen
Locator Setting Range Increment Unit
A Resistance 0 to 250 1 Ohms
B
PSI 0 to 250 1 psi
Bar 0 to 17.2 0.1 bar
kPa 0 to 1,724 1 kPa
DGC-2020HD Engine Sender Inputs