Basler Electric DGC-2020HD - Manual (Page 385)

9469300990 Rev B 375
Fault
Code String Description
506 AL LOW STARTER VOLTS Battery voltage is too low for starting.
507 AL POM ERROR A general POM error has been detected.
508 AL WRONG POM ID POM sends a different identification number (ID) than expected.
509 AL CHECK POM FUSE Check POM fuse.
510 AL OVERRIDE APPLIED Override applied.
515 STARTER NOT ENGAGED Starter of POM could not be engaged.
543 MULTIPLE FDH SLAVES There is more than one device which is configured as Backup for
FDH-Functionality.
544 CONFIGURATION CHANGED Gets active in case of changing system configuration e.g. by
changing ECU- or SAM-Device. Remains until undo procedure or
data is transferred by a valid maintenance case. Is cancelled
automatically.
549 AL PWR CUTOFF STR This is the alarm from the function Emergency Stop Counter. ECU
power was disconnected while the engine was still running. This
could lead to a possible overpressure in the high pressure system
which might damage the engine.
555 AL CALL FIELD SERVICE Gets active in case of completing a maintenance-case which
manipulates Engine-Parameters. Remains also after switching on-
off ECU until a valid release code is entered via Display- and
Button-Control of SAM-Device. Release Code is available via
Internet by a special procedure.
576 AL ESCM OVERRIDE STR Exceeding of the corrected current MCR - odr DBR/MCR value.
594 AL L1 PRV 1 DEFECT STR Yellow alarm pressure relief valve first rail.
595 AL L2 PRV 1 DEFECT STR Red alarm pressure relief valve first rail.
598 AL L1 PRV 2 DEFECT STR Yellow alarm pressure relief valve second rail.
599 AL L2 PRV 2 DEFECT STR Red alarm pressure relief valve second rail.
610 AL WIRING SUCK RESTRCT 1
STR Open load or short circuit on PWM HP fuel control block channel.
611 AL WIRING SUCK RESTRCT 2
STR Open load or short circuit on PWM HP fuel control block channel 2.
612 AL WIRING PRESS CTRL VLV 1
STR Open load or short circuit on PWM pressure regulating valve
channel.
613 AL WIRING PRESS CTRL VLV 2
STR Open load or short circuit on PWM pressure regulating valve
channel 2.
615 AL EIL PROTECTION STR Alarm for Protection Module in response to faulty or manipulated
EIL.
692 AL ECU PWR OFF ON REQ STR ECU configuration changed, switch power off/on.
696 AL SMARTCONCT USB ERR
STR Alarm configuration parameter.
697 AL SMARTCONCT RS485 ERR
STR Alarm configuration parameter.
698 AL SD STOP BUTTON STR Channel signals open load or internal error.
700 AL SD START BUTTON STR Channel signals open load.
701 AL SD UP BUTTON STR Channel signals open load.
702 AL SD DN BUTTON STR Channel signals open load or internal error.
703 AL SD EXT SPEED DMD SW STR Channel signals open load.
704 AL SD SPEED DMD INCREASE
STR Channel signals open load or internal error.
DGC-2020HD MTU Fault Codes