Basler Electric DGC-2020HD - Manual (Page 288)

278 9469300990 Rev B
Figure 179. Basler Electric Device Package Uploader
8. Click on the Upload button and the Proceed with Device Upload screen will appear. Select Yes or
No.
9. After selecting Yes, the DGC-2020HD Selection screen will appear. Select either USB or
Ethernet.
10. After file(s) have been uploaded, click the Close button on the Basler Electric Device Package
Uploader screen and disconnect communication to the DGC-2020HD.
Upgrading Firmware in the DGC-2020HD
Upgrade DGC-2020HD firmware and then load a saved settings file.
1. Upgrade the DGC-2020HD firmware.
a. Connect to the DGC-2020HD with BESTCOMSPlus. Check the firmware Application
Version on the General Settings > Device Info screen.
b. Select Upload Device Files from the Communication pull-down menu. You do not have to
be connected to the DGC-2020HD at this time. Save settings when prompted, if desired.
c. Open the desired device package file (dgc-2020hd.bef).
d. Check the box for DGC-2020HD Firmware. Note the version number of the DGC-2020HD
firmware; this is the version that will be used to set the Application Version in the settings
file in a later step.
e. Click the Upload button and follow the instructions that appear to begin the upgrade
process.
f. After the upload is complete, disconnect communication to the DGC-2020HD.
2. Load the saved settings file into the DGC-2020HD.
a. Close all settings files.
b. From the File pull-down menu, select New, DGC-2020HD.
c. Connect to the DGC-2020HD.
d. Once all settings have been read from the DGC-2020HD, open the saved settings file by
selecting File, Open File in the BESTCOMSPlus menu. Then browse for the file to
upload.
e. When BESTCOMSPlus asks if you wish to upload settings and logic to the device, click
Yes.
Device Information DGC-2020HD