Basler Electric DGC-2020HD - Manual (Page 346)

336 9469300990 Rev B
CEM-2020 DGC-2020HD
Remote Contact Outputs Configuration
A CEM-2020 provides 24 contact outputs and a CEM-2020H provides 18 contact outputs. The outputs
are designated CEM x Output #1 through CEM x Output #24 (where x = 1 to 4). Contact output logic
connections are made on the BESTlogicPlus screen in BESTCOMSPlus and contact output operational
settings are configured on the CEM x Outputs (where x = 1 to 4) settings screen in BESTCOMSPlus.
BESTCOMSPlus Navigation Path: Settings Explorer, Programmable Outputs, Remote Contact Outputs
Front Panel Navigation Path: Settings Explorer > Programmable Outputs > Remote Contact Outputs
Label Text
In order to make identification of the remote contact outputs easier, each of the outputs can be given a
user-assigned label. The label is an alphanumeric string with a maximum of 16 characters.
Logic Connections
Remote contact output logic connections are made on the BESTlogicPlus screen in BESTCOMSPlus.
The CEM 1 Output 1 logic block is illustrated in Figure 211.
Figure 211. Remote Contact Output Logic Block
Operational Settings
Remote contact output labels are configured on the CEM x Outputs (where x = 1 to 4) settings screen
(Figure 212) in BESTCOMSPlus.
Figure 212. Settings Explorer, Programmable Outputs, Remote Contact Outputs, CEM 1 Outputs
Firmware Updates
Refer to the Device Information chapter for information on upgrading firmware in the CEM-2020.
Repair
Contact Expansion Modules are manufactured using state-of-the-art surface-mount technology. As such,
Basler Electric recommends that no repair procedures be attempted by anyone other than Basler Electric
personnel.