Basler Electric DGC-2020HD - Manual (Page 205)

9469300990 Rev B 195
Connect a USB Cable
The USB driver was copied to your PC during BESTCOMSPlus installation and is installed automatically
after powering the DGC-2020HD. USB driver installation progress is shown in the Windows taskbar area.
Windows will notify you when installation is complete.
Connect a USB cable between the PC and your DGC-2020HD. Apply operating power to the DGC-
2020HD. Wait until the boot sequence is complete.
Start BESTCOMSPlus ® and Activate DGC-2020HD Plugin Automatically
To start BESTCOMSPlus, click the Windows Start button, point to Programs, Basler Electric, and then
click the BESTCOMSPlus icon. During initial startup, the BESTCOMSPlus Select Language screen is
displayed (Figure 135). You can choose to have this screen displayed each time BESTCOMSPlus is
started, or you can select a preferred language and this screen will be bypassed in the future. Click OK to
continue. This screen can be accessed later by selecting Tools and Select Language from the menu bar.
Figure 135. BESTCOMSPlus Language Selection Dialog
The BESTCOMSPlus platform window opens. Select New Connection from the Communication pull-down
menu and select DGC-2020HD. See Figure 136. The DGC-2020HD plugin is activated automatically after
connecting to a DGC-2020HD.
Figure 136. Communication Pull-Down Menu
The DGC-2020HD Connection screen, shown in Figure 137 appears. Select USB Connection and then
click the Connect button.
DGC-2020HD BESTCOMSPlus
® Software