Basler Electric DGC-2020HD - Manual (Page 384)

374 9469300990 Rev B
Fault
Code String Description
417 SD L WATER FUEL PREFILT Water level-sensor of fuel pre-filter defect.
420 AL L1 AUX 1 Input of Aux 1 injured limit 1.
421 AL L2 AUX 1 Input of Aux 1 injured limit 2.
428 AL L1 T AUX 1 Temperature input of Aux 1 injured limit 1.
438 LO P FUEL RAIL 2 STR Low pressure on fuel rail 2.
439 HI P FUEL RAIL 2 STR Hi pressure on fuel rail 2.
440 AL L1 P AUX 1 Pressure input of Aux 1 injured limit 1.
441 AL RAIL 2 LEAKAGE STR Alarm fuel rail 2 leak detected.
442 AL L2 P AUX 1 Pressure input of Aux 1 injured limit 2.
444 SD U PDU Sensor defect of Injector Power driver unit.
445 SD P AMBIENT AIR Ambient air pressure-sensor defect.
448 HI P CHARGE AIR Pressure of charge air too high (limit 1).
449 SS P CHARGE AIR Pressure of charge air too high (limit 2).
450 SD IDLE END TRQ IN Input of Idle/End-Torque defect
454 SS PWR RED ACT Power Reduction is activated.
455 AL L1 AUX1 PLANT Input of Aux 1 (plant) injured limit 1.
456 AL L2 AUX1 PLANT Input of Aux 1 (plant) injured limit 2.
461 LO T EXHAUST EMU Exhaust gas temperature of EMU too low (limit 1).
462 HI T COOLANT EMU Coolant temperature of EMU injured limit 1.
463 SD AUX 2 Sensor defect on Aux 2.
464 SD P AUX 1 Analog input for pressure Aux 1 defect.
467 AL L2 T AUX 1 Temperature input of Aux 1 injured limit 2.
468 SD T AUX 1 Analog input for Temperature Aux 1 defect.
469 SD AUX 1 Analog input for Aux 1 defect.
470 SD T ECU ECU temperature-sensor defect.
471 SD COIL CURRENT Coil Current sensor defect.
472 AL STOP SD Engine stop, because critical channel has sensor defect.
473 AL WIRING PWM CM2 Open load or short circuit on channel PWM_CM2.
474 AL WIRING FREQ OUT Open load or short circuit on frequency output (FO) channel.
475 AL CR TRIG ENG ST Released in case of an engine stop in order to trigger the crash
recorder.
476 AL CRASH REC ERR Initial error of crash recorder.
478 AL COMB ALM YEL Combined Alarm YELLOW (Plant).
479 AL COMB ALM RED Combined Alarm RED (Plant).
480 AL EXT ENG PROT External Engine Protection function active.
500 AL WIRING POM STARTER 1 A wiring fault has been detected in the connection of starter 1 of
POM.
501 AL WIRING POM STARTER 2 A wiring fault has been detected in the connection of starter 2 of
POM.
502 AL OPEN LD POM ALTRNATR An open load on POM’s alternator output has been detected.
503 AL BATT NOT CHARGING Battery is not being charged by alternator.
504 AL CAN POM NODE LOST POM is missing on CAN bus.
505 AL NEW POM FOUND New POM found.
MTU Fault Codes DGC-2020HD