Rockwell Automation 284 ArmorStart User Manual - Manual (Page 88)

3-26 Bulletin 280/281 Programmable Parameters
Starter Display
Zone Ctrl Enable
Global enable for ZIP peer-to-
peer messaging. This parameter
must be disabled before any
changes to the ZIP configuration
for the device can be made.
0=Disable
1=Enable
Parameter Number 99
Access Rule GET/SET
Data Type BOOL
Group ZIP Parameters
Units —
MinimumValue 0
Maximum Value 1
Default Value 0
Phase A Current
This parameter provides the
current of Phase A measured n
increments of 1/10
th
of an
ampere
Parameter Number 101
Access Rule GET/SET
Data Type INT
Group Starter Display
Units xx.x Amps
Minimum Value 0
Maximum Value 32767
Default Value 0
Phase B Current
This parameter provides the
current of Phase B measured in
increments of 1/10
th
of an
ampere
Parameter Number 102
Access Rule GET/SET
Data Type INT
Group Starter Display
Units xx.x Amps
Minimum Value 0
Maximum Value 32767
Default Value 0
Phase C Current
This parameter provides the
current of Phase C measured in
increments of 1/10
th
of an
ampere
Parameter Number 103
Access Rule GET/SET
Data Type INT
Group Starter Display
Units xx.x Amps
Minimum Value 0
Maximum Value 32767
Default Value 0
Average Current
This parameter provides the
average current measured in
increments of 1/10
th
of an
ampere
Parameter Number 104
Access Rule GET/SET
Data Type INT
Group Starter Display
Units xx.x Amps
Minimum Value 0
Maximum Value 32767
Default Value 0