Rockwell Automation 284 ArmorStart User Manual - Manual (Page 109)

Bulletin 283 Programmable Parameters 4-19
OutB Pr FltValue
This parameter determines the
state the Out B assumes when a
protection trip occurs and
Parameter 39 is set to “0”
0 = Open
1 = Close
Parameter Number 40
Access Rule GET/SET
Data Type BOOL
Group User I/O
Units —
Minimum Value 0
Maximum Value 1
Default Value 0
OutB DN FltState
This parameter in conjunction
with Parameter 42 defines how
Output B will respond when a
DeviceNet network fault occurs.
When set to “1”, Output B will
hold state prior to trip
occurrence. When set to “0”,
Output B will open or close as
determined by setting in
Parameter 42 Parameter Number 41
Access Rule GET/SET
Data Type BOOL
Group User I/O
Units —
Minimum Value 0
Maximum Value 1
Default Value 0
OutB DN FltValue
This parameter determines the
state that Output B assumes
when a DeviceNet network fault
occurs and Parameter 41 is set to
“0”
0 = Open
1 = Close
Parameter Number 42
Access Rule GET/SET
Data Type BOOL
Group User I/O
Units —
Minimum Value 0
Maximum Value 1
Default Value 0
OutB DN IdlState
This parameter in conjunction
with Parameter 44 defines how
Output B will respond when the
DeviceNet network is idle. When
set to “0”, Output B will open or
close as determined by the
setting in Parameter 44. The
DN Flt parameters supersede the
Dn Idl parameters Parameter Number 43
Access Rule GET/SET
Data Type BOOL
Group User I/O
Units —
Minimum Value 0
Maximum Value 1
Default Value 0
OutB DN IdlValue
This parameter determines the
state that Output B assumes
when the network is idle and
Parameter 43 is set to “0”
0 = Open
1 = Close
Parameter Number 44
Access Rule GET/SET
Data Type BOOL
Group User I/O
Units —
Minimum Value 0
Maximum Value 1
Default Value 0