Rockwell Automation 284 ArmorStart User Manual - Manual (Page 376)

C-4 Bulletin 283 CIP Information
Identity Objects A single instance of the Identity Object is supported. The following
instance attributes are supported.
Table C.4 Identity Object Instance Attributes
The following common services are implemented for the Identity
Object:
Table C.5 Identity Object Common Services
Message Router — CLASS CODE
0x0002 No class or instance attributes are supported. The message router
object exists only to rout explicit messages to other objects.
DeviceNet Object — CLASS CODE
0x0003 The following class attributes are supported for the DeviceNet Object:
Table C.6 DeviceNet Object Class Attributes
A single instance (instance 1) of the DeviceNet Object is supported.
The following instance attributes are supported.
Attribute ID Access Rule Name Data Type Value
1 Get Vendor UINT 1
2 Get Device Type UINT 22 or 133
3 Get Product Code UINT See Table C.1
4 Get
Revision
Major Revision
Minor Revision
Structure of:
USINT
USINT Indicates Software Firmware Revision Number
5 Get Status WORD
Bit 0 — 0=not owned; 1=owned by master
Bit 2 — 0=Factory Defaulted; 1=Configured
Bit 8 — Minor Recoverable fault
Bit 9 — Minor Unrecoverable fault
Bit 10 — Major Recoverable fault
Bit 11 — Major Unrecoverable fault
6 Get Serial Number UDINT Unique Number for Each Device
7 Get
Product Name
String Length
ASCII String
Structure of:
USINT
STRING
Product code specific
See Table C.1 and Table C.2
8 Get State USINT Returns the value “3=Operational”
9 Get Configuration Consistency Value UINT
Unique value depending on output of the parameter
checksum algorithm.
10 Get/Set Heartbeat Interval USINT In seconds. Default = 0
Service
Code
Implemented for:
Service
Name
Class Instance
0x0E Yes Yes Get_Attribute_Single
0x05 No Yes Reset
0x10 No Yes Set_Attribute_Single
Attribute ID Access Rule Name Data Type Value
1 Get Revision UINT 2