Rockwell Automation 284 ArmorStart User Manual - Manual (Page 196)

6-22 Bulletin 284 Programmable Parameters for Sensorless Vector Controllers
Display Group
Output Freq
Output frequency present at T1, T2, T3. Parameter Number 101
Related Parameters 102, 110, 134, 135, 138
Access Rule GET
Data Type UINT
Group Display Group
Units 0.1 Hz
Minimum Value 0.0
Maximum Value 400.0 Hz
Default Value Read Only
Commanded Freq
Value of the active frequency command. Displays the commanded frequency even if
the drive is not running. Parameter Number 102
Related Parameters 101, 113, 134, 135, 138
Access Rule GET
Data Type UINT
Group Display Group
Units 0.1 Hz
Minimum Value 0.0
Maximum Value 400.0 Hz
Default Value Read Only
Output Current
Output Current present at T1, T2, T3. Parameter Number 103
Access Rule GET
Data Type UINT
Group Display Group
Units 0.01
Minimum Value 0.00
Maximum Value Drive rated amps x 2
Default Value Read Only
Output Voltage
Output Current present at T1, T2, T3. Parameter Number 104
Related Parameters 131, 184, 188
Access Rule GET
Data Type UINT
Group Display Group
Units 1V AC
Minimum Value 0
Maximum Value 230V, 460V, or 600V AC
Default Value Read Only
DC Bus Voltage
Present DC Bus voltage level. Parameter Number 105
Access Rule GET
Data Type UINT
Group Display Group
Units 1V DC
Minimum Value
Based on Drive Rating
Maximum Value
Default Value Read Only