Rockwell Automation 284 ArmorStart User Manual - Manual (Page 155)

Bulletin 284 Programmable Parameters for Volts per Hertz Controllers 5-33
Control Source
Displays the source of the Start Command and Speed Reference.
Valid Start Commands for the Bulletin 284 ArmorStart are the following:
2 = 2-wire
3 = 2-wire Level Sensitive
4 = 2-wire High Speed
5 = RS485 (DSI) Port
9 = Jog
Valid Speed Commands for the Bulletin 284 ArmorStart are the following:
1 = Internal Frequency
4 = Preset Freq X
5 = RS485 (DSI) port
9 = Jog Freq Parameter Number 112
Related Parameters 136, 138, 151, 152
Access Rule GET
Data Type UINT
Group Display Group
Units 1
Minimum Value 0
Maximum Value 9
Default Value 5
Contrl In Status
Status of the control terminal block control inputs:
Bit 0 = Start/Run FWD input
Bit 1 = Direction/Run REV Input
Bit 2 = Stop Input
Bit 3 = Reserved
Parameter Number 113
Related Parameters 102, 134, 135
Access Rule GET
Data Type UINT
Group Display Group
Units 1
Minimum Value 0
Maximum Value 15
Default Value 0
Dig In Status
Status of the control terminal block digital inputs:
Bit 0 = Digital IN 1 Sel
Bit 1 = Digital IN 2 Sel
Bit 2 = Reserved
Bit 3 = Reserved Parameter Number 114
Related Parameters 151, 152
Access Rule GET
Data Type UINT
Group Display Group
Units 1
Minimum Value 0
Maximum Value 15
Default Value 0
Comm Status
Status of communications ports:
Bit 0 = Receiving Data
Bit 1 = Transmitting Data
Bit 2 = RS485
Bit 3 = Communication Error Parameter Number 115
Related Parameters 203…207
Access Rule GET
Data Type UINT
Group Display Group
Units 1
Minimum Value 0
Maximum Value 15
Default Value 0
Control SW Ver
Main Control Board software version for AC Drive. Parameter Number 116
Access Rule GET
Data Type UINT
Group Display Group
Units 0.01
Minimum Value 1.00
Maximum Value 99.99
Default Value Read Only