Rockwell Automation 284 ArmorStart User Manual - Manual (Page 146)

5-24 Bulletin 284 Programmable Parameters for Volts per Hertz Controllers
ZIP Parameters
AutoRun Zip
Enables ZIP data production on power up
0=Disable
1=Enable
Parameter Number 67
Access Rule GET/SET
Data Type BOOL
Group ZIP Parameters
Units —
Minimum Value 0
Maximum Value 1
Default Value 0
Zone Produced EPR
The Expected Packet Rate in msec. Defines the rate of at which ZIP data is
produced. Defaults to 75 msec.
Parameter Number 68
Access Rule GET/SET
Data Type UINT
Group ZIP Parameters
Units msec
Minimum Value 0
Maximum Value 65535
Default Value 75
Zone Produced PIT
The Production Inhibit Time in msec. Defines the minimum time between Change of
State data production
Parameter Number 69
Access Rule GET/SET
Data Type UINT
Group ZIP Parameters
Units msec
Minimum Value 0
Maximum Value 65535
Default Value 75
Zone #1 MAC ID
The node address of the device whose data is to be consumed for zone 1. When set
to the value 64, data consumption is disabled. .
Parameter Number 70
Access Rule GET/SET
Data Type USINT
Group ZIP Parameters
Units —
Minimum Value 0
Maximum Value 64
Default Value 64
Zone #2 MAC ID
The node address of the device whose data is to be consumed for zone 2. When set
to the value 64, data consumption is disabled.
Parameter Number 71
Access Rule GET/SET
Data Type USINT
Group ZIP Parameters
Units —
Minimum Value 0
Maximum Value 64
Default Value 64