Rockwell Automation 284 ArmorStart User Manual - Manual (Page 156)

5-34 Bulletin 284 Programmable Parameters for Volts per Hertz Controllers
Drive Type
Used by Rockwell Automation field service personnel. Parameter Number 117
Access Rule GET
Data Type UINT
Group Display Group
Units 1
Minimum Value 1001
Maximum Value 9999
Default Value Read Only
Elapsed Run Time
Accumulated time drive is outputting power. Time is displayed in 10 hour
increments. Parameter Number 118
Access Rule GET
Data Type UINT
Group Display Group
Units 1 = 10 hrs
Minimum Value 0
Maximum Value 9999
Default Value Read Only
Testpoint Data
The present value of the function selected in Parameter 202. Parameter Number 119
Related Parameter 202
Access Rule GET
Data Type UINT
Group Display Group
Units 1 Hex
Minimum Value 0
Maximum Value FFFF
Default Value Read Only
Analog In 0…10V
This parameter is not available for use with the Bulletin 284 ArmorStart Distributed
Motor Controller.
Parameter Number 120
Analog In 4…20 mA
This parameter is not available for use with the Bulletin 284 ArmorStart Distributed
Motor Controller.
Parameter Number 121
Drive Temp
Present operating temperature of the drive power section. Parameter Number 124
Access Rule GET
Data Type UINT
Group Display Group
Units 1
°
C
Minimum Value 0
Maximum Value 120
Default Value Read Only