Rockwell Automation 284 ArmorStart User Manual - Manual (Page 182)

6-8 Bulletin 284 Programmable Parameters for Sensorless Vector Controllers
DeviceNet Group
Network Override
This parameter allows for the local logic to override a Network fault.
0 = Disable
1 = Enable Parameter Number 8
Access Rule GET/SET
Data Type BOOL
Group DeviceLogix
Units —
Minimum Value 0
Maximum Value 1
Default Value 0
Comm Override
This parameter allows for local logic to override a loss of an I/O connection.
0 = Disable
1 = Enable Parameter Number 9
Access Rule GET/SET
Data Type BOOL
Group DeviceLogix
Units —
Minimum Value 0
Maximum Value 1
Default Value 0
Autobaud Enable
When this parameter is enabled, the device will attempt to determine the network
baud rate and set its baud rate to the same, provided network traffic exists. At least
one node with an established baud rate must exist on the network for autobaud to
occur.
0 = Disable
1 = Enable Parameter Number 10
Access Rule GET/SET
Data Type BOOL
Group DeviceNet
Units —
Minimum Value 0
Maximum Value 1
Default Value 1
Consumed I/O Assy
This parameter selects the format of the I/O data consumed Parameter Number 11
Access Rule GET/SET
Data Type USINT
Group DeviceNet
Units —
Minimum Value 0
Maximum Value 188
Default Value 164
Produced I/O Assy
This parameter selects the format of the I/O data produced. Parameter Number 12
Access Rule GET/SET
Data Type USINT
Group DeviceNet
Units —
Minimum Value 0
Maximum Value 190
Default Value 165