Rockwell Automation 284 ArmorStart User Manual - Manual (Page 175)

Chapter
6
Bulletin 284 Programmable Parameters
for Sensorless Vector Controllers
This chapter describes each programmable parameter and its function
for Bulletin 284 Sensorless Vector Controllers.
Parameter Programming Each Distributed Motor Controller type will have a common set of
parameters followed by a set of parameters that pertain to the
individual starter type.
Refer to Chapter 8, DeviceNet™ Commissioning, for instructions in
using RSNetworx
™
for DeviceNet
™
to modify parameter settings.
Refer to Chapter 11, ArmorStart® to ArmorPoint® Connectivity, for
instructions to modify parameter settings when using the Bulletin
284A with the ArmorPoint® distributed I/O products.
Important: Resetting the Factory Default Values Parameter 47, Set
to Defaults, allows the installer to reset all parameter to
the factory default values. It also resets the MAC ID to its
factory default after DeviceNet Power is cycled if
switches are set >63.
Important: Parameter setting changes downloaded to the
ArmorStart® take effect immediately, even during a
running status.
Important: Parameter setting changes made in a configuration tool
such as RSNetworx ™ for DeviceNet do not take effect in
the ArmorStart until the installer applies or downloads the
new settings to the device.