Rockwell Automation 284 ArmorStart User Manual - Manual (Page 418)

D-18 Bulletin 284 CIP Information
Discrete Input Point Object — CLASS CODE 0x0008 ➊
The following class attributes are supported for the Discrete Input
Point Object
Table D.40 Discrete Input Point Object Class Attributes:
➊ Note: This assembly does not exist for the Bulletin 284A.
Four instances of the Discrete Input Point Object are supported. All
instances will contain the following attributes
Table D.41 Discrete Input Point Object Instance Attributes:
The following common services are implemented for the Discrete
Input Point Object
Table D.42 Discrete Input Point Object Instance Common Services:
Attribute ID Access Rule Name Data Type Value
1 Get Revision UINT 2
2 Get Max Instance UINT 4
Attribute ID Access Rule Name Data Type Value
3 Get Value BOOL 0 = OFF, 1 = ON
115 Get/Set Force Enable BOOL
0 = Disable,
1 = Enable
116 Get/Set Force Value BOOL 0 = OFF, 1 = ON
Service
Code
Implemented for
Service
Name
Class Instance
0x0E Yes Yes Get_Attribute_Single
0x10 No Yes Set_Attribute_Single