Index 13 – Lenze ECSCPxxx User Manual
Page 450

Index
l
450
EDBCSXP064 EN 8.0
− "point−to−point" positioning, 193
− Basic terms
Profile continuation after profile abort, 96
Speed variation (override), 96
stretch factor for "electrical shaft", 96
torque limitation after positioning, 96
touch probe positioning, 93
− continuous constant travel, 195
− direct positioning, 198
− Electrical shaft ("E−shaft"), 196
− homing, 197
− positioning sequence for controller optimisation, 200
− relative positioning in the continuous measuring system,
− relative positioning with absolute reference, 97
− state control, operating states, 111
− States of the positioning drive
− states of the positioning drive
Homing, 112
ManualJog, 112
PosFunctions, 111
Positioning, 112
Trouble, 111
− touch probe positioning, 194
Positioning , absolute positioning , 97
Positioning profile mode, selecting, 191
Positioning profile additional features, Profile
continuation function, Activate, 96
Positioning profile modes
− absolute positioning, 193
− absolute positioning (direct), 198
− continuous constant travel, 195
− continuous constant travel (direct), 199
− Electrical shaft ("E−shaft"), 196
− homing, 197
− positioning sequence for controller optimisation, 200
− relative positioning in the continuous measuring system,
− relative positioning in the continuous measuring system
− relative positioning with absolute reference, 194
− relative positioning with absolute reference (direct), 199
− reset reference, 197
− setting the reference, 197
− touch probe positioning
absolute , 194
relative in the continuous measuring system, 195
relative with absolute reference, 195
Positioning profile parameters, 97
− acceleration, 98
− deceleration, 98
− final speed, 98
− jerk time, 99
− setting, 201
− target position, 97
− traversing speed, 98
Positioning sequence for controller optimisation, 200
− connection of external brake resistor, 59
− DC bus connection, 52
− Internal brake resistor connection, 57
− motor connection, 52 , 60
− motor holding brake connection, 52
− plug connector assignment, 52
− connection of motor holding brake, 61
− DC bus connection, 54
− of the axis module, device status, 163
− structure, 418
− to the axis module, 158
Process data objects
− addressing, 429
− available, 417
− cyclic, 420
− event−controlled, 422
− transfer, 419
Profile continuation function