Configuration – Lenze EVS9332xK User Manual
Page 353
Configuration
Code table
8.4
l
8.4−79
EDSVS9332K EN 8.0−07/2013
IMPORTANT
Possible settings
Code
Selection
Lenze
Designation
No.
C1702
s
® Selection list 3 CLUTCH3
Configuration of input signals
1 CLUTCH3−TARG
ET−POS
1000 FIXED0INC
The "disengage" function depends on the
mode set under C1707:
l
C1707 = 0: After CLUTCH3−CLOSE = LOW,
the clutch opens along the set ramps and
stops in the position applied to
CLUTCH3−TARGET−POS.
l
C1707 = 1: After CLUTCH3−CLOSE = LOW,
the clutch runs synchronously until the
position applied to CLUTCH3−TARGET−POS
is reached and opens subsequently. The
standstill position results from the speed
and the set ramp.
2 CLUTCH3−DIST
1000 FIXED0INC
Reserved
3 CLUTCH3−PHI−S
ET
1000 FIXED0INC
Set position of the master shaft
4 CLUTCH3−PHI−
ACT
1000 FIXED0INC
Actual position of the master shaft
5 CLUTCH3−LEN
1000 FIXED0INC
Clock pulse length (X axis)
C1703
g
{1 inc}
CLUTCH3
Display of input signals
1 (C1702/1)
... ...
5 (C1702/5)
C1704
s
CLUTCH3−LOW
−VEL
1000 FIXEDPHI−0
® Selection list 4 CLUTCH3
Configuration of input signal
Selection of a minimum speed at which the
drive is to rotate after disengaging.
C1705 (C1704)
g −32767
32767 CLUTCH3
Display of input signal
C1706
0.010
{0.01 s}
50.000 CLUTCH3
1 Open−Instant/
Rampe
1.000
Deceleration time of the ramp at
CLUTCH3−OPEN−INSTANT = HIGH
(disengaging)
2 Öffnungszeit/R
ampe
1.000
Deceleration time of the ramp at
CLUTCH3−CLOSE = LOW (disengaging)
3 Schließzeit/Ra
mpe
1.000
Acceleration time of the ramp at
CLUTCH3−CLOSE = HIGH (engaging)
C1707
s
0
CLUTCH3
Clutch mode
0
Time−controlled: target = TARGET−POS
After CLUTCH3−CLOSE = LOW, the clutch
opens along the set ramps and stops in the
position applied to CLUTCH3−TARGET−POS.
1
Time−controlled: start opening at
TARGET−POS
After CLUTCH3−CLOSE = LOW, the clutch runs
synchronously until the position applied to
CLUTCH3−TARGET−POS is reached and opens
subsequently. The standstill position results
from the speed and the set ramp.
C1708
0
{1 rpm}
15000 CLUTCH3
1 Window of
master speed
in starting
position
10
Speed window for master speed at the time
of clutch−in (starting position)