Lenze EVS9332xK - Manual (Page 217)

Commissioning
Transfer of motion profiles
Transfer methods
6
6.11
6.11.1
l
6.11−1 EDSVS9332K EN 8.0−07/2013
6.11 Transfer of motion profiles
6.11.1 Transfer methods
EVS93xx-xK
C0002
CDATA
EEPROM
RAM2
C0387
C0003
CDATA-LOAD = HIGH
MCTRL
*.LC7
*.LC7
RAM1
1
2
3
0
9300kur072
Fig. 6.11−1 Different transfer methods
Transfer of profile data Description
From To
GDC (cam editor) Þ Controller 0 Transfer of profile data created in the "cam editor" of
GDC to the background data field (RAM2) of the
controller. Subsequent transfer of data to the active data
field (RAM1).
^ 6.11−3
GDC (basic data) Û Controller 1 Loading of profile data from the controller to GDC via the
"Basic cam data" dialog box. Subsequent transfer of data
from GDC to other controllers.
^ 6.11−3
PLC/IPC Þ Controller 2 Transfer of profile data from GDC (*.LC7) or CamDesigner
(*.txt) to the PLC or IPC. Subsequent transfer of data to the
controller:
^ 6.11−3
l Block transfer ^ 6.11−4
l Interpolation−point−oriented transfer ^ 6.11−6
l Code−oriented transfer
– Due to the complexity of this transfer method not
recommended by Lenze.
^ 13.1−1
Controller Þ PLC/IPC 3 Block transfer ^ 6.11−9