Ag Leader EDGE Ver.4.5 Users Manual - Manual (Page 86)

74
I
MPLEMENT
T
AB
Individual implements are set up and configured from the
Implement Tab. The Implement List displays all previously-
configured implements that are available for use.
• Add
Press to add a new implement. A wizard will walk you through
setting up the implement.
• Keyboard Button
Press to edit the name of a selected implement from the list.
• Wrench Button
Press to edit the Swath Section Offsets. For more information, see
“Implement Offsets” on page 74.
• Remove
Press to remove a selected implement.
Note: When deleting an implement all data in the regions and configurations using it will be deleted!
I
MPLEMENT
O
FFSETS
After you complete the initial process of configuring an Implement, you must enter accurate values in the
Section Offsets to ensure proper machine performance. Section Offsets are configured as outlined in the
following steps.
Section Offsets
1. Press Wrench Button
On the Implement Tab, highlight the Implement Configuration,
press the Wrench Button, and the Implement Offsets screen
appears.
2. Enter left or right distance from hitch point
Use the numeric keypad to enter the distance of the midpoint of the
swath section from the machine centerline. Select Left or Right to
indicate the direction the swath section is located from the vehicle
centerline.
3. Enter Forward or Backward Distance from Hitch Point
Use the numeric keypad to enter the distance from the front or back of the hitch point. Press the checkmark
box when complete.
C
ONTROLLER
T
AB
Use the Controller Tab to add and configure SeedCommand controllers for use during SeedCommand
planting operations.
Note: No settings are available under the Controller Tab that pertain to Area Logging (non-SeedCommand)
planting operations.