Ag Leader EDGE Ver.4.5 Users Manual - Manual (Page 183)

171
H
ARVEST
H
ARVEST
S
ETUP
T
ABS
Pressing the Harvest button at the Setup Screen
takes you to the Grain Harvest Configuration Tab. This tab is
shown in front of four other tabs: Combine, Header, Crops
and Calibration.
• Configuration Tab
The Configuration Tab is where you can add and edit operating configurations. For more information, see
“Create a Harvest Configuration” on page 171 and “Configuration Settings” on page 172.
• Combine Tab
The Combine Tab is where you can set up and configure additional combines. For more information, see
“Combine Tab” on page 173.
• Header Tab
The Header Tab is where you can set up and configure additional headers. For more information, see
“Header Tab” on page 174.
• Crops Tab
The Crops Tab is where you can add and edit crops. For more information, see
“Crops Tab” on page 176.
• Calibration Tab
The Calibration Tab is where you can perform calibrations. For more information, see
“Pre-Harvest
Checklist” on page 178.
C
REATE A
H
ARVEST
C
ONFIGURATION
To set up a Harvest configuration, you must set up a Combine and Header configuration with the
following procedure.
1. Press Harvest button
At the Setup screen, press the Harvest button.
The Configuration Tab opens, as shown.
2. Press the Add button
The Operating Configuration Wizard appears.