Ag Leader EDGE Ver.4.5 Users Manual - Manual (Page 52)

40
SmartPath
The SmartPath pattern is designed to give guidance
from any previously-driven pass. This is used in
irregular-shaped and terraced fields where you cannot
run all passes parallel to the previous pass. Instead, the
SmartPath guidance allows you to move to a different
area of the field, and then resume a previous guidance
pattern later. Moreover, you can use SmartPath to
create straight AB patterns within the SmartPath
pattern and cycle between any available pattern within
SmartPath to choose the appropriate one.
Creating a SmartPath Pattern
1. Press New Pattern
At the Guidance Screen, press the New Pattern button.
2. Select Pattern
The New Pattern Screen appears.
3. Select SmartPath
Select SmartPath from the drop-down list of available guidance
patterns.
4. Change Guidance Width (optional)
In addition to these Guidance Options, a default Guidance Width is shown, based on the Implement Width
that you specified in Implement Configuration. If you wish to change this Guidance Width, enter the new
number using the numeric keypad. Press the green check mark box when finished.
Note: Guidance Width allows you to use guidance lines independent of implement width.
5. Drive the SmartPath
The Map Screen changes its appearance to Perspective View, and the Active Line Cycle button appears
on the Map Screen.