Ag Leader EDGE Ver.4.5 Users Manual - Manual (Page 194)

182
18. Examine Error Percentage
When the calibration is finished, a screen appears, stating “Full
Calibration Complete.” Examine the error percentages before
checking the check mark box.
19. Uncheck Loads With Excessive Error Percentages
At the Weight Calibration Screen, take note of any calibration loads
that have excessive error percentages. In the example below,
Region 3 has an error percentage of 21.8 percent.
You should be able to calibrate the display for grain weight to
an average error of 1% to 3%. If the average error is more than
3%, uncheck the load with the maximum error. Then re-
perform the calibration by pressing the Perform Calibration
button.
Note: You must still have at least four calibration loads checked in order to perform a full calibration.
A
DDING A
N
EW
C
ALIBRATION
If you notice a decreased yield accuracy, you may need to perform a new calibration. To do this, use the
following procedure.
1. Select Crop to Calibrate
Press the Grain Harvest button
and then go to the Calibration Tab, as shown. Use the drop-down
menu to select the crop to calibrate.
2. Press Weight Button
At the Calibration Tab, press the Weight button, and the Weight
Calibration Screen appears, as shown.