Ag Leader EDGE Ver.4.5 Users Manual - Manual (Page 55)

43
G
UIDANCE
Save Pattern
You can save a pattern (.pat file) to the display's internal memory to the current field by using the
following procedure.
1. Press Save Pattern
The Save Pattern screen appears, as shown.
Note: The Save Pattern button will appear when there is an active pattern.
2. Name the pattern
Press the keyboard button and enter a unique pattern name. When finished, press the green check mark
box.
Notes:
• To verify that the pattern is saved, you can open the Save Pattern screen again by pressing the Save
Pattern button. Your newly-saved or named pattern should now appear in the Save Pattern screen.
• You may remove all of the patterns by pressing the Remove All button. A warning appears, stating “All
guidance patterns will be permanently erased from memory.” If you wish to do this, press the green
check mark box to continue.
Reset Pattern
If you have been using an already-saved pattern, and wish to
switch over to a different pattern in the same field, you can use
the Reset Pattern feature by following the steps below.
1. Press Reset
Press the Reset button on the Guidance screen.
2. Confirm Reset
The Guidance screen appears, asking you to reset the current
guidance pattern. Press the green check mark box to continue.
3. Create new pattern (optional)
The pattern is now reset. You may now create a new pattern, if desired.
Load Pattern
You can load a pattern from the display's internal memory to the current field by using the following
procedure.
1. Press Load Pattern
Press the Load Pattern button on the Guidance screen.