Ag Leader EDGE Ver.4.5 Users Manual - Manual (Page 144)

132
R
ATE
S
CREEN
: L
IQUID
F
LOW
/P
RESSURE
DirectCommand users applying liquid products can use the bottom active area of the Rate Screen to
view settings for Flow, Main Pressure, and Agitator Pressure. This screen also displays the Serial
Number of your DirectCommand Liquid Product Controller.
R
ATE
S
CREEN
: S
PINNER
S
PREADER
S
ETTINGS
DirectCommand users applying granular products with a
Spinner Spreader can use the bottom active area of the Rate
Screen to view Fan Speed, adjust Product Settings and
Spreader Control settings.
The Rate Screen below is shown for a two-channel Spinner
Spreader. The channel that you wish to view is shown in a bin-
shaped icon placed between two wedge shapes.
CAUTION: Changing any of these settings in the display does not make the needed adjustments on the
product applicator. Setting value and physical setting on the spinner bed must be verified for correctness
prior to any product application.
• Information on Product Settings is described on “Spinner Spreader Product Settings” on page 132.
• Information on Spreader Control settings is described on see “Spreader Control” on page 133.
Spinner Spreader Product Settings
Spinner Spreader Product Settings can be accessed by pressing the Product Settings button, located
at the bottom active area of the Rate Screen.
Notes:
• Each of these settings described below, and at “Spreader Control” on page 133 , must be set for each
individual Product Channel (bin).
• Changing any of these settings in the display does not make the needed adjustments on the product
applicator. Setting value and physical setting on the spinner bed must be verified for correctness prior to
any product application.