Ag Leader EDGE Ver.4.5 Users Manual - Manual (Page 79)

67
P
LANTING
This Tab is shown in front of four other tabs: Vehicle,
Implement, Controller and Product.
• Configuration Tab
The Configuration Tab is where you can add and edit operating
configurations. For more information, see
“Create a Planting
Configuration” on page 67 and “Configuration Settings” on page 68.
• Vehicle Tab
The Vehicle Tab is where you can add and edit vehicles. For more
information, see
“Vehicle Tab” on page 72.
• Implement Tab
The Implement Tab is where you can add and edit implements. For more information, see
“Implement Tab”
on page 74.
• Controller Tab
The Controller Tab is where you can add and edit controllers for use during planting. For more information,
see
“Controller Tab” on page 74.
• Product Tab
The Product Tab is where you can add new products or edit existing products for planting. For more
information, see
“Product Tab” on page 75.
C
REATE A
P
LANTING
C
ONFIGURATION
To set up a Planting configuration, you must set up Vehicle, Implement, Controller and Products with the
procedure described on this and following pages.
1. At the Setup screen, press the Planting button.
2. The Configuration Tab opens, as shown.
3. Press the Add button.