Ag Leader EDGE Ver.4.5 Users Manual - Manual (Page 185)

173
H
ARVEST
2. Press the Calibrate Distance button, and the Speed Sensor
Calibration wizard appears, as shown.
3. From here, follow the on-screen wizard’s instructions to
complete the distance calibration procedure.
C
OMBINE
T
AB
Underneath the Combine Tab, you can view, add, rename or
remove combines, or adjust combine settings.
• Add button
Add a configuration
• On-screen Keyboard
Edit or rename existing combines
• Wrench button
Access Combine Settings
• Minus button
Remove a configuration
Note: When deleting a combine all harvest data logged with the configuration will be deleted.
C
OMBINE
S
ETTINGS
By highlighting the configuration and pressing the
Wrench button on the Combine Tab, you can
summon the Combine Settings screen, where you
can access Combine Settings, Map Delays, or adjust GPS
Offsets.
Advanced Combine Settings
The Combine Settings button allows you to change the advanced settings for the selected combine.
The values should not be changed unless instructed to do so by Technical Support.
CAUTION: Do not change any of the advanced combine settings without specific instruction from Technical
Support.
Map Delays
Press to change the Map Delay settings.