Ag Leader EDGE Ver.4.5 Users Manual - Manual (Page 84)

72
AutoSwath Notes
To use AutoSwath for planting operations, you are required to use a 5 Hz or higher GPS output rate.
AutoSwath control will not allow sections to be turned on until the master and planting section switches
are on. If you have less than a 5 Hz GPS output rate and you select AutoSwath, a warning appears,
telling you that AutoSwath Control is not available at less than 5 Hz.
Fixing Overplanting and Underplanting in AutoSwath
Turn Off Look-Ahead
Overplanting
Increase look-ahead number
The AutoSwath anticipates headlands sooner and turns the planter off sooner.
Underplanting
Decrease look-ahead number
The AutoSwath anticipates headlands later and turns the planter off later.
Turn On Look-Ahead
Overplanting
Decrease look-ahead number
The AutoSwath anticipates headlands later and turns the planter on later.
Underplanting
Increase look-ahead number
The AutoSwath anticipates headlands sooner and turns the planter on sooner.
V
EHICLE
T
AB
The Vehicle Tab provides functionality for setting up and
configuring vehicles. The vehicle list will show any vehicles
that have already been created.
• Add
The Add button allows you to add a new vehicle. A wizard will walk
you through the vehicle setup process.
• Keyboard Button
The Keyboard button allows you to edit the name of a vehicle in the
list. To edit, highlight the name of a vehicle in the list and then press
this button.
• Wrench Button
The Wrench Button button opens the Vehicle Settings Screen, where you can configure GPS Offsets. For
more information, see
“GPS Offsets” on page 72.
• Remove
The Remove button allows you to remove a vehicle.
Note: If a vehicle is deleted, all data in the regions and configurations using it will be deleted.
GPS O
FFSETS
After completing the process of setting up a Vehicle, you must also configure GPS Offsets. The GPS
Offsets define where machine rear axle, hitch, and product placement is in relation to the GPS antenna.